 |
||
|
Glass Tube Rotameter |
||
|
|
Spink controls offers an Industrial flowmeter used to measure flow rate of liquids & gases. It operates on the variable area principle, where the fluid flow raises a float in taper tube, increasing the area of passage of fluid. The greater the flow, the higher the float is raised. The height of float is directly proportional to the flow rate. With liquids, the float is raised by a combination of the buoyancy of the liquid and the velocity head of the fluid. With gases, the buoyancy is negligible, and float responds to the velocity head alone. The taper glass tube is formed of Borosilicate glass of extremely high accuracy of bore obtained by collapsing the taper tube while in hot and plastic state on a precision ground and polished mandril. The tubes are then annealed in furnace to relieve the stress formed during manufacturing. Floats of various configuration and material are used for a wide range of application depending upon flow rate, viscosity and turbidity of fluid. The float has a sharp metering edge where the reading is observed by means of scale mounted along side of the tube. The scale of rotameter is calibrated to directly read the fluid flow. The flow rate for any variable area flow rate can be expressed as  |
|
|
|
||
